DOCUMENT SSE-0000077399-01 - V
17
–
Configuring a standalone MorphoAccess®
T
ERM
INA
L
CO
NF
IG
UR
AT
IO
N
T
ER
MI
NAL
CO
NF
IGU
RAT
IO
N
T
ER
MI
N
A
L
CO
NFIGUR
ATI
O
N
T
ER
MIN
AL
CO
N
FIG
UR
AT
IO
N
T
ER
M
IN
A
L
CO
NFIGURATI
O
N
T
ER
MIN
AL
CO
NF
IG
U
RAT
IO
N
Principle
This feature is available to change network parameters (IP, address, mask and
gateway).
Store a file on a USB mass storage key
The administrator creates a configuration file on a PC using the
USB Network
Configuration Tool.
This
configuration file
contains new network
parameters. This file must be stored on a USB mass storage key.
Figure 3 • 1: Build a setting file on a USB mass storage key
Apply changes on a standalone terminal
The front window of the MorphoAccess
®
must be removed to give access to
the USB Host Interface of the terminal. The terminal must be powered on.
When the USB mass storage key is inserted in the MorphoAccess
®
USB
interface, the
configuration file
is read: network parameters are applied.
Figure 3 • 2: Apply setting file to the MorphoAccess
®
At the end of the process, two medium-pitched «beeps» indicates that the USB
mass storage key can be removed.
Please refer to
USB Network Configuration Tool User guide
for more
information about this procedure.
Summary of Contents for MorphoAccess J-Bio
