PXI
™
, National Instruments
™
, and ni.com
™
are trademarks of National Instruments Corporation. Product and company names mentioned herein are
trademarks or trade names of their respective companies.
322909A-01
©
Copyright 2000 National Instruments Corp. All rights reserved.
November 2000
INSTALLATION GUIDE
TB-2705 PXI T
ERMINAL
B
LOCK
FOR
E S
ERIES
AND
W
AVEFORM
G
ENERATION
D
EVICES
This installation guide describes how to install and connect signals to
the TB-2705 terminal block for use with PXI E Series and waveform
generation devices.
Introduction
The TB-2705 is a terminal block assembly consisting of a printed circuit
board, 62 screw terminals, and a plastic enclosure with a strain relief. The
terminal block assembly connects directly to the front panel of National
Instruments E Series and waveform generation devices, eliminating the
need for an external cable.
The TB-2705 allows you to easily connect analog input, analog output,
counter-timer, and digital I/O signals to your National Instruments device.
The 62 screw terminals allow access to every pin on the device with the
exception of some digital ground signals that are common to one another.
The TB-2705 also has a shielded strain-relief to secure your I/O wires and
provide an adequate chassis-ground connection.
What You Need to Get Started
You need the following to set up and use your terminal block:
❑
TB-2705 Terminal Block Assembly
❑
TB-2705 PXI Terminal Block for E Series and Waveform Generation
Devices Installation Guide
❑
One of the following:
–
PXI E Series device
–
waveform generation device with a 68-pin I/O connector
™
