6.
Memory Backup:
This warmer is equipped with a
5-minute memory backup
. It provides backup power to the status indicator system for a
short period of time in the event that the power switch is shut off, or power cord is removed from the wall outlet. If power is interrupted, the
status indicators will remember the status of all the packages in the warmer at that time and reinstate those settings when power is restored
within 5 minutes.
7.
Premoistened cloth and hair care products manufactured by Sage Products Inc.:
Refer to individual product package for instructions,
ingredients, warnings and other information.
4.
Replacement parts and service:
Before performing any repairs or service on this warmer, contact Sage Products.
5.
Fuses:
This warmer is equipped with two externally accessible fuses. Turn off and unplug the warmer before attempting to remove fuses. If the
warmer stops running, check the fuses on the back side of the cabinet’s exterior. If a fuse is blown, replace it with another fuse of identical
rating. If the new replacement fuse blows, contact Sage Products for further instructions.
1.
Unplug the warmer before cleaning.
2.
Keep the inside of the warmer clean. If spatters or fluid adhere to walls, wipe with a damp cloth. Mild detergent may be used if the warmer
gets very dirty. The use of harsh detergent or abrasives is not recommended.
NEVER
clean the warmer with alcohol or solvent-based
cleansers. Alcohol or solvents on door(s) or status indicator display columns can weaken and cause cracking of these components.
3.
The outside warmer surfaces should be cleaned with a large, damp cloth. To prevent damage to the operating parts inside the warmer, water
should not be allowed to seep into the ventilation openings or any other openings on the cabinet exterior. Use cloths that have been
dampened with mild detergent solution only, but not so wet as to drip liquid or cause liquid to pool in warmer.
4.
If external electrical components become wet, including the display columns, power cord, power switch on front of cabinet and external
fuse access (if so equipped), clean with a soft, dry cloth and allow to air dry.
DO NOT
use harsh detergents or abrasives on any
external components.
5.
Cleaning inside the warmer outer panels and inside the warmer base should be performed only by qualified service personnel after taking
precautions to drain all stored voltage potential. Contact Sage Products for authorized service.
Adjusting the Temperature
The warmer is capable of warming products to a user-defined temperature. The user has the ability to adjust the temperature between 100°F and
125°F ± 5°F (35°C - 55°C).
1.
Press the MENU key below the display from the default temperature display screen.
2.
Using the UP/DOWN arrow keys located to the right of the display, highlight SET TEMPERATURE and press the SELECT key below
the display.
3.
When prompted, enter the following key sequence: UP ARROW, DOWN ARROW, UP ARROW.
4.
Using the UP/DOWN arrow keys, select the desired temperature for the contents of the warmer.
5.
After the desired temperature is selected, press the SAVE/EXIT key located below the display.
–
If you wish to discard the changes, press the CANCEL key located below the display.
6.
The warmer will then display the temperature set point on the main screen.
–
If the temperature of the warmer falls outside of the set point ± 5°F, the display will read the actual temperature of the warmer.
CARE OF YOUR WARMER
ACCESSING THE USER-DEFINED FEATURES
CAWR227
