background image

This warmer is to be used SOLELY for premoistened cloth and hair care products manufactured by Sage Products Inc. The warmer has been

designed and safety tested to be used exclusively with these products. ANY other use of the warmer by the facility including, but not limited to,

use with other bathing products, can result in overheating, fire or other hazardous conditions and is expressly forbidden.

WARNING:

To reduce the risk of fire, burns, electrical shock or injury:

1.

Read all instructions before using this warmer.

2.

Grounding reliability can only be achieved when the equipment is connected to an equivalent receptacle marked “hospital only” or

“hospital grade.”

3.

Install this warmer only in accordance with the installation instructions found in this manual.

4.

DO NOT

cover or block any openings on this appliance.

5.

DO NOT

tamper with or make any adjustments to the control panel, housings, safety switches, or any other part of the warmer.

6.

DO NOT

remove any panel or cover.

7.

DO NOT

store or use this appliance outdoors.

DO NOT

use this product near water—for example, near a kitchen sink, in a wet basement,

or near a swimming pool.

8.

DO NOT

use this warmer for any material other than premoistened cloth and hair care products manufactured by Sage Products, in

accordance with instructions on the label.

9.

DO NOT

let the cord hang over edge of table or counter.

10.

This warmer is to be used by adults familiar with its operation and these safety instructions.

11.

DO NOT

operate this warmer if it has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped.

12.

DO NOT

immerse cord or plug in water.

13.

Keep cord away from heated surfaces.

14.

The warmer is to be serviced only by qualified service personnel. If there are no external or user-serviceable fuses, contact Sage Products for

repair or adjustment. If there are external or user-serviceable fuses, check them and replace if necessary. If new fuses do not correct the

condition, or if fuses continue to blow, contact Sage Products for repair or adjustment.

15.

Use this appliance only for its intended purpose as described in this manual.

DO NOT

use corrosive chemicals or vapors in this appliance.

This type of warmer is specifically designed to warm premoistened cloth and hair care products manufactured by Sage Products. It is

NOT

designed for industrial or laboratory use. The use of corrosive chemicals in heating or cleaning will damage the appliance and may

result in product failure.

16.

TO REDUCE THE RISK OF FIRE:

Warm only premoistened cloth and hair care products manufactured by Sage Products.

DO NOT

use to heat or store any other material or products.

If materials inside the warmer should ignite, keep the door(s) closed, turn the warmer off, and disconnect the power cord, or shut

off power at the fuse or circuit breaker panel.

Do not operate the warmer empty—always have some premoistened cloth and hair care products in warmer when it is in use (it is not

necessary to fill every slot).

17.

DO NOT

store flammable materials in the proximity of the warmer. It could be a fire hazard.

18.

Equipment not suitable for use in the presence of a flammable anesthetic mixture with air, or with oxygen or nitrous oxide.

19.

This warmer uses conduction heating.

20.

The warmer should

NOT

be adjusted outside of menu driven options by anyone except properly qualified personnel. Contact Sage Products

for authorized service.

IMPORTANT SAFETY INSTRUCTIONS

CAWR227

Summary of Contents for 7938









Reviews: