USER MANUAL
EvaluationTools
STIM300 STIM377H Evaluation Kit
DOK453 rev.2
Page 28 of 29
16
Unable to synch with DG-stream !
Failed to acquire the requested number of datagrams from the gyro
module, unable to get in synch with datagram stream
17
Error encountered when trying to print, check configuration !
Failed to print the graph, check that a printer is configured
18
Unable to create result-folder specified by parameter !
The specified pathname cannot be created, either due to access-rights or
errors in the path specification
19
Unable to enter service-mode !
Unable to enter service-mode, does not receive expected response to
command.
20
Unable to save parameters to active INI-file !
Error encountered when trying to save parameters onto INI-file
21
Edit-mode of parameters is active, unable to exit !
The edit-mode of parameters are active, unable to exit the program until
edit mode is ended
22
You are about to change the RS422 bit rate.
If are you using the USB kit hardware provided, please notice that you
will not be able to communicate with the device if you change to
something else than supported 460800 b/s!
For the PCI card there are no worries - it supports all available bit
rates
A warning to the user about limitations for certain RS422 hardware
23
Unable to create/save to selected file, check access rights to folder
Unable to open or create the specified file in the selected folder, try
another filename and/or location. The reason may be lacking access
rights to the folder, or illegal filename format
24
Unsupported datagram received
When trying to read datagrams into memory a datagram type not
supported by the EVK is detected
Table 11: Possible messages given by the program
