QUICK START GUIDE
20
S
T
E
P
T
W
O
:
W
IR
IN
G
Power Supply
Use an external power supply that provides a minimum of :
- 12V/3A or 24V/1.5A for device only.
- 12V/10A peak or 24V/8A peak for cooler module only.
The external power source must be a SELV and a Limited DC Power
Source, as defined in IEC 60950-1 standard (except if it is used to
supply both device and cooler module).
A battery backup or uninterrupted power supply (UPS) with built-in
surge protection is recommended.
Power Over Ethernet (PoE)
When the device is powered over Ethernet, an IEEE 802.3at compliant Active Midspan
Injector must be used. This injector is not supplied with Morpho EAS products.
4G V-Station Extreme Power
WARNING:
1. Under powering may cause memory and data corruption; over powering may cause hardware damage.
Both of these situations will void the warranty.
2. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
NOTE:
Only PHIHONG injectors (with the listed characteristics) are supported.
PoE Injector Specs
• PHIHONG Single Port Injector
• Input Voltage: 100-240V, 50-60Hz
• Input Current: 1.90A
• Output Voltage: 56V
• Output Current: 0.6A
• Power: 60W
