V2.0 2021 Copyright Safewaze
Page 17
Average Arresting Force
≤ 1,350 lbs (6.0kN)
Maximum Arresting Force
≤ 1,800 lbs (8.0 kN)
Maximum Arrest Distance
24 in (0.61 m)
6.4 MAXIMUM ARREST FORCE AND MAXIMUM ARREST DISTANCE
SRL’s documented in this instruction manual meet the following Arrest Force and Arrest Distance maximums when tested in accordance with Section
4.2.1 of ANSI Z359.14.
TABLE 7 - CLASS A
8.1 BEFORE EACH USE
Before each use ensure that the equipment is in good working condition. Inspect the unit to ensure it has not been damaged and that the unit pays out
and retracts properly. Prior to each use, the braking system must be inspected. Grasp the body of the unit in one hand and the cable/web in the other.
With a quick, jerking motion, pull down on the web/cable. The brake should engage, stopping movement almost immediately. Inspect the webbing
and/or cable (using “Inspection Checklist” Page 20) and ensure that all connection hardware is working properly. Brake failure or unsatisfactory results
during any portion of the inspection, require immediate removal of the SRL from service. Figure 21 points out key inspection areas of the Latitude HD
series of SRL’s.
8.2 INSPECTION FREQUENCY
The Safewaze SRL - must be inspected at the intervals defined in Section 2.3. Inspection procedures are described in the “Inspection Checklist”
(see Page 20). Annual inspections by a Competent Person other than the user must be recorded in the Inspection Log on (Page 22) of this manual.
8.0 INSPECTION
8.3 UNSAFE OR DEFECTIVE CONDITIONS
Figure 22 shows examples of equipment damage. Equipment inspectors must be trained to look for damage as illustrated in (Figure 22), as well as other
damage that may occur. If inspection reveals an unsafe or defective condition remove the SRL from service.
7.3 STORAGE
Store Safewaze SRL’s in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL
after any period of extended storage.
7.1 SERVICE
Remove the SRL from use if the SRL has been subjected to fall arrest forces or inspection reveals an unsafe or defective condition. If unrepairable
Dispose of the SRL as recommended in Section 8.5.
7.2 CLEANING
Cleaning procedures for Safewaze SRL’s are as follows:
Periodically clean the exterior of the SRL using water and a mild soap solution. Clean labels to maintain readability.
An excessive buildup of debris on the cable/web may prevent the cable lifeline from fully retracting back into the housing and create a potential free fall
hazard.
Clean webbing using water and a mild soap solution. Allow to dry fully before using or allowing web to fully retract into housing.
Clean cable using an acid-free oil or petroleum jelly at regular intervals. Always wear gloves when servicing/inspecting steel cable SRL’s.
7.0 MAINTENANCE, SERVICING, AND STORAGE
IMPORTANT:
If the lifeline comes in contact with acids or other caustic chemicals, remove the SRL from service and wash with
water and a mild soap solution. Inspect the SRL (using the Inspection Checklist on Page 20) before returning to service.
8.4 PRODUCT LIFE
The working life of Safewaze SRL’s is determined by work conditions, care and inspection provided. As long as the SRL passes inspection, it may
remain in service.
8.5 DISPOSAL
Dispose of the Safewaze SRL if it has been damaged by fall arrest forces or inspection reveals an unsafe or defective condition that cannot be repaired
by an authorized Safewaze Service Center. Before disposing of the SRL, cut the cable/web lifeline in half so that it is not mistakenly reused.
Average Arresting Force
≤ 900 lbs (5.0kN)
Maximum Arresting Force
≤ 1,800 lbs (8.0 kN)
Maximum Arrest Distance
54 in (1.37 m)
TABLE 7 - CLASS B
