37
Operation
Set the individual flip stops to the positions desired for repetitive cuts: loosen the collars with the provided Allen
wrench, slide the collars to the desired position, and retighten them.
Multiple cuts can be made by flipping the stops up or down to position the work piece at the proper distance from
the blade or bit. When setting multiple stops, remember to account for the material lost to the blade kerf.
Quick Stop
The Quick Stop Accessory provides an easy method of setting an exact repeatable cut length for crosscuts and
vertical routing cuts. It consists of an aluminum angle extrusion with movable tape measure, a large aluminum
stop block with threaded lock knob, and mounting brackets and screws. The Quick Stop can be attached to any
horizontal frame member, on any model saw. Standard Quick Stops are factory-drilled to mount on the left side of
the frame; right-hand Quick Stops are available by special order.
It is standard on the Models 7400 and 7400XL, and is not available for the Model TR2.
Installation
CAUTION:
Before beginning installation, disconnect the power supply to the motor,
raise the carriage to the top of the guides, and lock the carriage in place with
the lock knob.
CAUTION:
Be sure the tool frame is securely supported and cannot be tipped over
during this installation procedure. An additional person should support and
stabilize the frame at all times during the installation.
1. Attach the two mounting brackets to the long aluminum angle bar of the Quick Stop as shown in Figure 42,
using the screws provided.
Figure 42: Installing the Quick Stop
(viewed from rear of frame)
2. Set the assembled angle bar on the next-to-lowest horizontal bar on the left side (as you are looking at the
frame in Figure). You will cover the standard ruler on the machine when you install this accessory.
Figure 43: Installing the Quick Stop
3. Push the Quick Stop as far toward the center of the tool as possible.
4. Using the mounting bracket holes as a template, drill four 7/32” (5.55mm) holes in the tool frame.
5. Attach the brackets to the frame, using four ¼(6.35mm)-20 self-tapping hex-head screws.
6. Measure from the blade or bit, and adjust the Quick Stop measuring tape by sliding it in the angle extrusion.
Angle Bar
Mounting Bracket
Stop Block