9
Operation and Adjustment
UPPER ROUTER HEIGHT ADJUST
POWER FEEDER HEIGHT ADJUST
FIGURE 9
FIGURE 10
3. Upper Router Height Adjust (FIGURE 9)
(Accutrim system)
A.
With the machine in the “off” position use a sample piece of panel, slide the panel forward
till it passes under the Upper Cutter Contact bearing. The router should lift up approximately
1/16”. If not, loosen the two knurled jamb nuts and adjust till the correct height is achieved,
then lock the jamb nuts to secure setting.
NOTE: At first, this adjustment can be performed
with the feeder lifted to full height and swung away (see section on power feeder height
adjustment). Once the operator is more familiar with the machine, the adjustment is easily
done with the feeder lifted slightly, so the panel can be slid through without contacting the
belt feeder.
4. Power Feeder Height Adjust (FIGURE 10)
A.
Take a sample of panel to be banded and lay it on the tabletop slides parallel to the front of
the power feeder.
B.
Lower the feeder until the top of the panel is approximately 2MM (3/32”) higher than the
bottom of the rubber feed belt or a 3/32” from the bottom of the feeder roller.
NOTE: Be
sure to tighten both feeder-locking screws before operating and loosen both before
adjusting height or the level of the feeder may be disturbed and re-levelling will be
necessary.(Reference Fig.5 & 6 )
To swing the power feeder away for cleaning or making adjustments, loosen the rear locking
lever then completely remove the front locking lever 2 (Reference Fig. 5 & 6). Raise the
feeder using the crank handle to its full height and swing towards the outfeed end of the
machine.
NOTE: The dust collection hose must be removed first as well as unplugging the
power feeder supply cable. FAILURE TO UNPLUG THE FEEDER CABLE MAY
RESULT IN DAMAGE TO THE CABLE AND OTHER ELECTRICAL COMPONENTS.
Upper Cutter
Lower Cutter
Knurled Jam Nuts
Crank Handle
