10
Operation and Adjustment
FIGURE 11
FIGURE 12
5. Opening End Access Doors
A. To open end access doors
(FIGURE 11),
use a 1/8 allen wrench to remove the 10-24 flat
head screws located in table top at either end of machine. When closing the doors be sure
that the retention screw is aligned correctly and won’t become cross-threaded.
NOTE: End access doors must remain closed at all times during operation and should only be
opened after power has been disconnected to avoid possible electrical shock.
6. Powerfeeder Leveling
If powerfeeder level has been altered by accidentally raising or lowering feeder without loosening
infeed locking handle, it can be re-levelled by the following procedure.
A.
Loosen feeder mount cross bolt just slightly with a 9/16 wrench
(FIGURE 12),
just enough
so that feeder will rotate on support post with a moderate amount of pressure on the infeed
end.
B.
Using a small piece of melamine (approximately 2” x 3”) as a gauge, slide melamine piece
under #2 and #6 wheels and adjust tilt of feeder until it is perfectly level (within 1/64”) from
front to back.
C.
Tighten cross bolt when finished and re-check level to be sure the feeder hasn’t moved while
retightening.
NOTE: It is imperative that the feeder be parallel with tabletop. If your panel does not
stay tight to the guide fences while operating check the feeder level and adjust if
necessary.
