Safety 1st Grow and Go Sport, Instructions Manual, Page: 22 / 32

38 37
7. Place Child Restraint Rear
Facing in Back Seat
The level line on shell MUST be parallel
with the ground.
9. Tighten Belt
Place hand in child restraint.
Firmly push child restraint down and
back towards the vehicle seat back
while pulling free end of belt to tighten.
It may be easier to pull pad away from
shell and tighten the belt through the
belt path opening as shown.
10. Check Belt Tightness
Hold child restraint at the belt path with
your weakest hand.
Push and pull from side to side.
It should not move more than 1 in.
(2.5 cm).
8. Connect UAS to Vehicle
Anchor
NOTE: The UAS connector’s red release
button MUST face away from child
restraint and the arrows on connectors
MUST face up.
Fasten one UAS connector to the UAS
anchor bar in the vehicle seat bight.
Repeat for other side of child restraint.
To Release UAS
Remove child from child restraint.
Remove UAS from vehicle anchors by
pressing the red release button on each
connector.
Store UAS when not in use. See page 30.
11. Secure Child in Child
Restraint
Recheck level line.
Repeat steps 7-10 if level line is not
parallel with the ground.
NOTE: You may need to place a large
rolled towel(s) or foam pool noodle(s)
under front of child restraint to help
achieve the correct recline angle.
Check often to be sure padding is still in
place and the belt is tight.
If it moves more than 1 in. (2.5 cm), you can try:
A. Pulling the belt tighter.
B. Reinstalling the child restraint.
C. Changing to a different seating location.
D. Switching to vehicle belt installation.