Place Child Restraint in
Vehicle Rear-Facing in the
Back Seat
Fully recline
the child
restraint. To recline, see
section C-6.
41
F. Install Rear-Facing with Vehicle Belts
F-4
Install Rear-Facing with
Vehicle Belts
Do not use the UAS along with
the vehicle lap or lap/shoulder
belt. Secure UAS belts when
using the vehicle belts.
Check the vehicle belt before each use. Use
only if the belt is tightened properly and
securely.
Secure the tether hook to the
tether attachment when used
rear-facing.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle that
matches the weight of your child. Do not use any
other recline positions rear facing. Do not rotate
the child restraint beyond the bottom or top level
to ground lines.
Failure to follow these warnings can result in
serious injury or death.
42
continued on next page.
2.
Pull Pad Off Corners of
Child Restraint
Pull the seat pad off the front
corners of shell.
1.
Review section D-4 to determine what kind of vehicle belts you
have. Review your vehicle’s owner manual for seat belt use.
Rotate Child Restraint to
Correct Recline Angle
For children between 2.3-
10 kg (5-22 lb),
the bottom
level to ground line must be
level with the ground.
For children between
10-18 kg (22-40 lbs) and are able to sit up
unassisted,
rotate the child restraint between the top and
bottom level to ground lines.
NOTE:
Only if needed, you
may use a rolled towel(s) or
foam noodle(s) under the front
of the child restraint where
the vehicle’s seat back meets
the vehicle’s bench seat to get
the correct recline angle.
3.
Thread Vehicle Belt
Thread the vehicle lap or lap/
shoulder belt through the rear-
facing belt path.
With an ALR belt, pull the
belt all the way out before
threading.
With a switchable retractor, pull the shoulder belt all the
way out to switch the retractor into the ALR mode before
tightening.
4.
4358-6199 Elite Eng.indd 43-44
4358-6199 Elite Eng.indd 43-44
10/11/12 4:11 PM
10/11/12 4:11 PM
