IN064-01
Advanced maintenance work
Adjusting the lift level.
B.6.
Reset correct lift height on a S4 gun.
Only when to reset a maladjusted gun.
B.6.1.
Fit the instrument SAFE 91245 on the
gun as in B.5.
B.6.2.
Connect the cables to the Pinbrazing
unit and switch on the power.
B.6.3.
Take off the plastic plug with the
needle in the upper small hole in the
front of the gun.
IMPORTANT, never adjust in the
hole where the big plug is!
B.6.4.
When lift height is too
low
.
Use the 3mm hexagon spanner and
adjust the screw in the small hole
anti-clockwise
about 1/4 of a turn
then check with the instrument as in B.5.
B.6.5.
When lift height is too
high
.
Use the 3mm hexagon spanner and
adjust the screw in the small hole
clockwise
about 1/4 of a turn then
check with the instrument as in B.5.
If all is ok, fit the plug in the hole again.
If not ok, send for repair.
