IN064-01
B3. Check that the ring holder is the right type.
B4. Load the gun with a 8mm pin and ferrule.
Check that the axle move easily with the pin and ferrule
fitted when moving back and forward.
If not, change either pin holder or ring-holder.
If it still doesn´t move easily the axle is damaged
And the gun must be sent for repair
.
IMPORTANT! The normal lift height is 2mm (setting 0) this is
very important for the arc and energy amount. Too high lift
height increase the risk of a “cold brazing”, too low lift height
reduce the time and increase misfires.
B.5.1.
Insert this end in to the gun.
B.5.2.
Turn on the unit and
Important!
Press the tool completely against the gun then
pull the trigger. Otherwise the gun may be damaged!
Important!
Hold the gun so the tool is horizontal.
B.5.3.
The lift level is calibrated when the inner rod, made of brass,
on the tool is in same level as the outer plastic sleeve.
Tolerance ±0,2 mm
.
If the gun is not calibrated see separate instruction for
adjusting of the gun.
