5. Pairing with Safera
Power Control (PCU)
5.1 Pairing with PCU
1. Install a Safera Power Control unit as
instructed in chapter 4.2 and then
continue the pairing from the step 2
below.
2. Switch off the power at the isolation
switch.
3. Press button 1 for five seconds until you
hear a signal and OK-button is lit blue.
4. Switch on the power at the isolation
switch. The Power Control Unit will now
contact the Sensor unit which gives a
sound signal (•••).
5. Open Safera App and go to the “Install a
new Safera Sense” section (this section
may launch automatically at this
point). The App will guide you through
the setup with questions about your
Unicook Airis sensor installation and
type of hob.
5.2 Check the working order
1. Turn on one cooker plate with maximum
power. With an induction cooker use a
suitable dish.
2. Press and hold the OK-button for 5
seconds: the system should cut off the
cooker power.
3. Test that none of the cooker plates and
oven (if connected to the stove guard)
are operable: if ok, switch off cooker
and oven.
4. Return the cooker power by pressing
the OK-button: the Indicator Light
should blink green once. If not, see
Troubleshooting in chapter 8.
5. Working order checked successfully:
Date Installer
ѥ
WARNING
If you are replacing the cooker or the
power control unit, pair the power con-
trol unit again and run the “installation
wizard” in the mobile app again.
Extra buttons
1 & 2