Safer Locks SAFER-BR-600, Installation Instructions Manual

Page: 8 / 21

1.
2.
3.
4.
5.
6.
7.
8.
the round knurled nut to either tighten or loosen the handle.
Once all adjustments have been made,
TIGHTEN the square nut.
Tighten the Clamp Screw. (Fig. 16)
Fig. 14
Fig. 15
3.4 Installing the Override Assembly
Back the Handle Clamp Screw out enough to separate the two sides of the Clamp.
Run the Cable from the top of the Cam Wheel and under the Pulley as shown in red (Fig. 14)
Open the Adjuster Cover to give enough slack in the Cable for the Handle Clamp to reach the wheelchair
handle. Spread the Clamp and position onto the handle of the wheelchair. (Fig. 15)
Insert the cable end into the appropriate slot in the Override Adjuster and close the cover. (Fig. 17)
When the Handle is pulled and just touching the bottom, the Lock Pin should fully disengage into the
Lock Pin Assembly.
Fine adjustments are made by loosening the square nut at the top of the Override Adjuster and turning
Fig. 16 Fig. 17
Page 8