Luna PED Firmware 2.6.0-6 Upgrade Instructions
PN: 007-012337-002, Rev. B, Copyright © 2015 SafeNet, Inc., All rights reserved.
Page 4 of 6
USB Mode
Software update
Uploading image…
3. The output of the update command in the Windows command prompt should be similar to the following:
LunaPED_Update v2.1.0-0 Nov 25 2013 12:44:48
PED operation is required (to upload image)...
(Sent 928562 bytes in 72571000 microsecs).
PED operation is required (to save image)...
4. If the image has transferred correctly, Luna PED displays the following message:
USB Mode
Software update
** WARNING **
A power failure during save is unsupported!
Save Image? YES/NO"
Select
Yes
to save the new image.
5. Wait approximately 20 seconds. The PED displays the following message:
USB Mode
Software update
Success
Press ENTER
Press the
Enter
key on the PED to continue.
6. I
f Luna PED displays an error “(SOCKRX)” this is most likely due to failure to respond to PED prompts in time.
Press
Enter
on the PED to return to USB Mode, and try again to transfer the file and then save the image on
the PED, responding more quickly to PED prompts. Similarly, if you receive an error at the Windows command
prompt that is similar to one of the following messages, take the appropriate action, as indicated:
Error message
Description
ERROR: rx error (-1) #2
This error might occur if there is a connection error, for example, if Luna PED
prompts are not answered in time, or if there is a bad USB connection or cable.
Repeat the upgrade operation. If it continues to fail, try using a different cable,
or change the cable location to reduce interference. Ensure that you respond to
the PED prompts in a timely fashion.
ERROR: software update
was cancelled (-1)
This error might occur if you attempt to transfer files and update PED
components out of order.
7. Unplug all cables from the PED and then reconnect to restart the PED.
8. As the PED boots, verify that the following message is displayed:
BOOT 1.0.6-2
Once rebooted, you may see a message
Nothing to Upgrade!
. Please ignore this message, and proceed to
”, below.
Note
: The PED displays
IPL V.2.5.0-0
on the
Select Mode
screen.
