Luna PED Firmware 2.6.0-6 Upgrade Instructions
PN: 007-012337-002, Rev. B, Copyright © 2015 SafeNet, Inc., All rights reserved.
Page 5 of 6
Step 2: Transfer and Confirm
ped-2.6.0-6-full-real.bin
The second file is larger and takes a little longer to transfer and install.
1. Allow the PED to boot
– after successful completion of the steps in the previous section, the PED should boot
directly to “USB Mode”.
2. In the command prompt window, execute the following command:
prompt>
LunaPED_Update.exe ped-2.6.0-6-full-real.bin
3. At the Luna PED, select
Yes
in response to the prompt:
Software update. Upload Image? YES/NO.
Wait approximately six minutes. While transfer is in progress, the command line shows a progress indicator
(remaining bytes to transfer), and the PED display shows:
USB Mode
Software update
Uploading image…
4. The output of the update command in the Windows command prompt should be similar to the following:
LunaPED_Update v2.1.0-1 Nov 25 2013 12:44:48
PED operation is required (to upload image)...
(Sent 4196354 bytes in 327977000 microsecs).
PED operation is required (to save image)...
5. If the image has been sent correctly, Luna PED displays the following message:
USB Mode
Software update
** WARNING **
A power failure during save is unsupported!
Save Image? YES/NO"
Select
Yes
to save the new image.
6. Wait for 20-30 seconds. When the PED displays the following message:
USB Mode
Software update
Success
Press ENTER
Press the
Enter
key on the PED keypad to return to USB mode.
7. Unplug all cables from the PED and then reconnect to restart the PED.
8. As the PED starts booting, it should display the following messages
BOOT V.1.0.6-2,
loading PED…
Local PED Mode Awaiting command…
If
you press “<” to exit to “Select Mode” menu, the bottom of the PED screen should now show “PED V.2.6.0-6”.
Done
Luna PED is now updated and ready to use. Repeat the above sequence for each Luna PED that you own.