13
SL2 v. 2.01 EN
Configuration
OTHER CODES
CODE DATA COMMENTS
Indicator mode
*78*
- # 0 = Standard
1 = Strictly EN81-28
2 = Strictly single EN81-28
Voice communication time-out *79*
- # 1 - 20 minutes. Standard = 8 min
Reset active alarm automatically *80*
#
0 = OFF
1 = ON (Default)
Auto answer
*81*
- - # No of signals before SafeLine answers incoming call. Can
be set from 00-16 (Default = 02, 00=Unit will not answer).
Unit number
*82*
- # Program Unit number 1-9 (Default = 0)
Detect dial tone
*83*
- # 0 = Off
1 = On (Default)
Set to off if SafeLine has problem to detect the dial tone.
Receipt to alarm receiver with
P100 protocol
*84*
- # Select which message(s) to send to the alarm receiver
at an alarm call.
0 = None (Default)
1 = Start of alarm
2 = Start+end of alarm
Break on new alarm
*86*
- # Disconnects a call longer than 60 seconds at new
activation of the alarm button and calls the next emer-
gency call number.
0 = OFF
1 = ON (Default)
Alarm button delay time
*87*
- - # Delay time from pressing the alarm button until acti-
vating the alarm.
00-25 seconds. (Default = 05)
Alarm button type
*89*
- # 0 = Normally-open contact, NO (Default)
1 = Normally-closed contact, NC
Change password
*91* - - - - # Change password (default=0000)
Simulate an alarm event
*94*
- # Triggers an alarm event after programming is terminated.
1 = Emergency call
2 = Test alarm
3 = Battery failure
4 = Microphone/Loudspeaker failure
5 = Receipt on voice call
6 = Maintenance
7 = Main unit power failure
8 = Stuck button alarm
Tone/Voice detection
*95*
- # 0 = Off (Default)
1 = On
Battery capacity check
*98*
- - # When the battery capacity goes over the set value (10-
25%) the SL2 will send a battery alarm. Recommended
for lead-acid batteries 0,8 - 2,3 Ah
00 = inactive
[10, 15, 20, 25] = percentage the battery capacity has
dropped, (default =20)
99 = reset battery reference, in case the battery has
been replaced.
Reset to default settings
*99*
- # 1 = Factory default
2 = Default P100(The following codes will be set):
*21*0#, *22*0#, * 27*03#, *80*1#, *84*1#, *88*1#
3 = Default CPC(The following codes will be set):
*21*3#, *22*3#, *27*03#, *80*1#, *84*1#, *88*1#
4 = Default VOICE(The following codes will be set):
*21*1#, *22*1#, * 27*03#, *80*1#, *84*1#, *88*1#
5 = Default France (The following codes will be set):
*21*1#, *22*1#, *23*1#, *24*1#, *27*3#, *31*4#,
70*1#,*80*0#, *84*2#, *89*1#, *98*20#
