Page 2
www.safe-t-cover.com 1-800-245-6333
Version 2.0
FIG. 1
NOTE: model sizes and configurations vary, see the Enclosure Plan View.
4.
Assemble the “A#-B” (corner) assemblies through the holes provided using Hex Head Screws. (For
best results, insert a bead of silicone caulk into the inside bend of the “A#” panel corners.) Set them on
the marked concrete base (Fig. 1).
5.
Position the “A1-A2” (end) panels firmly together and then assemble them using Hex Head Screws
through the holes provided making sure that the panels are pulled tightly together before tightening
the screws. (For best results, insert a bead of silicone caulk into the inside bend of the “A1” panel
flanges.)
6.
Set the “C” (access) panels and the “F” (support) posts in place in the following roof assembly steps
while trying to maintain about a
3
/
16
” gap on both sides of each “C” (access) panel. Measure and verify
the inside length of the enclosure during assembly progress. If the length does not match the Enclosure
Plan View, compensate by increasing or decreasing the suggested
3
/
16
” gaps until the inside length is
correct. Try to maintain the same gap at all gap locations.
7.
Use the “C” (access) panels for support while placing one of the “D1” (roof) panels on a “B-A1-A2-B”
(corner-end-corner) assembly and then fasten the roof as shown through the holes provided (Fig. 2)
using three (3) Hex Head Screws.
8.
Insert an Inside Roof Clip into the “D1” (roof) panel at the “A2” panel stud (Fig. 2C) and then attach
it as shown using one (1) Hex Head Screw.
