Reverse With Confidence
™
9
INST
ALL
ATION
Sensor Installation (In-Bumper Flush Mount)
For vehicles equipped with a bumper that can accommodate the Sensors,
carefully drill a 25mm hole and insert the Rubber Jacket, properly orientated
“UP”, in the hole first. Then insert the Sensor, again properly orientated “UP”
Depending on the thickness and construction of the bumper, the hole diam-
eter may need to be varied. The Rubber Jacket is designed to seat properly
into a 25mm hole with a 1/8 inch (3.2mm) thick metal bumper. If this is not
the case, the flanges on the Rubber Jacket must be taken into consideration.
It is suggested that a test hole be utilized to confirm a proper fit.
1) Depending on the vehicle type, select an appropriate location to mount the
water-tight control module on the rear undercarriage of the truck chassis.
Control Module Installation
