Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
4
CON-8505
ASSEMBL
Y INSTR
UCTIONS– GEN 1 CONDUIT CARRIER
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Flat Washer
Lock Nut
CONDUIT CARRIER
MOUNTINGS
3.1
3.2
M8 X 65MM Bolts
CROSSBAR PREPARATION-FRONT
Find the center of the top of Front Crossbar between the inner
bends. Using a grease pencil, mark the center, then measure
out 3.50” to the left and right of that center mark and mark
again using the grease pencil. The marked distances will
measure 7.00” across as shown below.
2.1
Prior to drilling, mark a center line along the length of the
Crossbar to ensure the holes are correctly centered.
2.2
Drill holes using a
3/8” steel drill bit.
2.3
Must remain loose enough to
position the Conduit Carrier.
3.4
Place Conduit Carrier onto Crossbars, then assemble Conduit
Carrier Mountings on top securing the Conduit Carrier to the
Crossbars using the provided hardware. Do not tighten the
Mountings until Step 3.6.
3.3
Flat Washer
Summary of Contents for PRIME DESIGN CON8505
Page 10: ...Page Intentionally Left Blank ...
Page 11: ...Page Intentionally Left Blank ...
Page 12: ...USAM CON8505 US01 Rev D 0818 ...
