Place the second J Shelf over the top of the U-
Brace rectangle and between the End Panels, and
push down into position. If necessary, use the rubber
mallet (or hammer with a block of wood) at each
corner as before, to be sure the barbs engage the
pockets.
7
Slide a K Locking Plug into the center channel of
one of the End Panels, with the slanted barb facing
the End Panel and the notched corner up and facing
the center of the cart. Push the Locking Plug down
between the End Panel and the Shelf, until the barb
snaps into place. Repeat at the other End Panel.
9
8
Align the L Endcap over the H End Panel
Without Holes
. Press firmly down until it
snaps into place (it may help to snap one end
first, then the other; or carefully use a rubber
mallet, or a hammer with a block of wood, to
tap it into place).
10
5332-37: 3 of 4; Rev. 1: 10/01
Safco Products Company, New Hope, MN 55428
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
K
BARB
NOTCH
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
L
Place one of the J Shelves between the End
Panels, near the bottom of the U-Brace rectangle.
Press the Shelf down firmly, keeping the tabs at the
outside corners of the Shelf aligned with the slots in
the End Panels. If necessary, tap gently with a rubber
mallet (or a hammer with a block of wood to protect
the surface) at each of the four corners until the barb
on the Shelf corner enters the pocket in the End Panel
(see inset). Resnap the U-Braces.
Q
Q
Q
Q
Q
BARB
SLOTS
Q
Q
Q
Q
Q
J
Q
Q
Q
Q
Q
J
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
H (Without Holes)