Assemble the two I U-Braces to form a rectangle,
snapping the two sections together at the overlapping
ends. IMPORTANT: find the word “TOP” molded into
the upper corners; this will identify the top of the
rectangle for the next step.
3
5
Slide the assembled U-Brace rectangle (with the
top up) down into the channels in the End Panels.
There are keyhole slots and studs, similar to those
on the Base Plate and End Panels. As the rectangle
approaches the bottom of the channel, push the
End Panels together and continue sliding the
rectangle down all the way into the channel in the
Bottom Plate.
If the side studs have properly
engaged the keyhole slots, the inside face of the
U-Brace rectangle will be flush with the End
Panel.
4
6
5332-37: 2 of 4; Rev. 1: 10/01
Safco Products Company, New Hope, MN 55428
Q
Q
Q
Q
Q
Temporarily unsnap the top of the U-Brace rectangle,
and spread the End Panels slightly until the ends of the
U-Braces touch each other.
UNSNAP AND
SPREAD APART
The two J Shelves should already have the two
center panels snapped together as shown; if they
have come apart, snap them together now. Fold the
two end panels out.
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
J
Q
Q
Q
Q
Q
I