18
D) Installation instructions
Bolting on the brake calliper
Position the brake calliper and screw in M 16 x 1.5 x 55 collared
bolts (tightening torque 290 Nm).
Coat ABS sensor (see arrow) all around with copper paste and
install in the sensor holder.
Push in the ABS sensor until it contacts the exciter.
Measure the output voltage at the ABS sensor cable using a
voltmeter (approx. 100 mV) while turning the brake disc or wheel
flange.
Examining the boots on the tappets
The boots on the tappets (66.1) and caps must have no cracks or
other damage.
Check that the tappets and boots fit correctly and replace the
tappets with boots, if necessary.
Examining the brake calliper guide system
The brake calliper (59/60) must move smoothly and easily over the fill
travel distance > 30 mm on the guide elements (80.2) and (80.3) or
(70.2) and (70.3) when pushed by hand (use no tools).
The guide bush (80.2) is sealed with boot (80.4) and boot cap (82).
Parts (80.4) and (82) must not be cracked or damaged.
Check that these parts are seated correctly.
Boot and boot cap must not be cracked or damaged. If necessary,
reseal or repair.
New type steel cap:
Check for correct seating of the steel cap item 83.1, renew if
necessary.
66.1
80.4 80.2 80.3
82
83.1
83.2
59/60
70.2
70.3
