25
D) Installation instructions
Fit the bellows using the special tool P/N 81922 into the brake
calliper.
Push the outer part of the folding bellows into the slot of the guide
pin and secure with the bellows ring.
The mounting surfaces - the linings in the brake mounting on the
pressure plate; if these are to be used again then they are to be
cleaned with a wire brush.
Do not grind or sand.
Lubricate the fitting surfaces of the guide pins on the brake moun-
ting with copper paste (SAF Part No. 4 387 0020 00).
Push out the guide pins so that they are free for the brake moun-
ting to be assembled.
Set the brake mounting in place on the brake calliper and press
in the guide pins so that they slide into the lead in of the brake
mounting.
Note!
Danger of injury! Grip only from the outside! Do not damage
the bellows!
Lubricate the threads of the 4 guide pins with copper paste
(SAF Part No. 4 387 0020 00) and screw in.
Tighten to
220 ± 20
Nm using a torque wrench and the special
tool (TORX E 18 nut).
81922
(consists of
three parts)
220 ± 20 Nm
Summary of Contents for SK RB 9022 H
Page 4: ...NOTIZEN NOTES NOTE 4...
Page 33: ...NOTIZEN NOTES NOTE 33...
