15
D) Installation instructions
Check the brake calliper for free and easy movement.
Screw out the pressure pin on the adjuster so far until the folding
bellows with the compression spring is visible.
Perform a visual inspection of the boots and all seals.
Screw in the tappets again completely.
Replacing the brake disc
Screw out the M 18 x 1.5 Hex. screws or the M 18 x 1.5 headed
TORX screws and remove the wheel flange.
Note:
Bolts must not be oiled!
(Observe tightening torques)
Press the brake disc off the hub unit with 3 hexagon head bolts
M 12 x 30.
Clean contact surfaces before assembly.
Caution!
Seal on axle nut must not be damaged as this would invalidate all
warranty claims.
Summary of Contents for SK RB 9022 H
Page 4: ...NOTIZEN NOTES NOTE 4...
Page 33: ...NOTIZEN NOTES NOTE 33...
