INSTRUMENT CONFIGURATION
The programmable parameters in the instrument are:
Operation mode (MULTI, SINGLE, DIRECT)
Continuous transmission frequency (from 1 to 5 Hz)
Communication protocol: (continuous or on request)
RF transmission power (from 0.15mW to 10 mW)
The programming of these parameters is performed using the PC application PWIN38 that allows through a
wizard to configure the RF system in few steps. The PC is connected via USB port used as Virtual COM
Port; alternatively the PC can be connected via Rs232. Refer to the manual of the software for the program-
ming procedures. The communication parameters are fixed at 38400,N,8,1.
RRF installation and operating manual
Pag. 11
