Saeco Tchibo Cafissimo Series HD8603, Operating Instructions Manual

Page: 39 / 216

• 29 •
Warning! never drink the descaling solution or any
products dispensed until the cycle has been com-
pleted. never use vinegar as a descaling solution.
1- Turn the machine off by pressing the On/Off button .
2- Check that the carafe is correctly inserted and filled with water
up to the MIN level, that there is no capsule in the compartment
and that the lever is lowered.
3- Remove and empty the water tank, drip tray and used capsule
drawer.
4-
Pour the contents of the bottle of descaling solution into the
water tank and fill it with fresh water up to the MAX level.
5- Put the tank back into the machine.
6- Push the drip tray all the way into the machine and raise the dis-
pensing spout.
7-
Place a container with a minimum capacity of 1 litre under the
the coffee and milk dispensing spouts.
8-
At the same time, press the On/Off button (green) and the
Cappuccino button (white) for 3 seconds, then release.
9- The machine indicates that the process has started when the
service indicator light (orange) is constantly lit; the Espresso
button (white) will also be constantly lit to indicate the first
phase of the descaling operation.
during descaling, the On/Off button (green) will not
operate. if the power cord is removed, the machine will
continue the descaling cycle from the phase in which it was
interrupted the next time it is turned on.
10
- Press the Espresso button (white) to start dispensing the
descaling solution.
The machine dispenses the descaling solution at regular intervals
via the coffee dispensing spout and via the carafe. The Espresso
button (white) flashes throughout this first phase.
the cycle can be temporarily suspended by pressing
the rinse button . Press it again to continue with
the descaling process.
11- The service indicator light (orange) starts to flash once all the
descaling solution has been dispensed.
12-
Empty the container into which the descaling solution was collect-
ed and reposition it under the milk and coffee dispensing spouts
after the drip tray has been emptied and replaced.
The Cappuccino button will light up automatically.
13- Empty the water tank and rinse it thoroughly. Thereafter fill it up
to the maX level with fresh drinking water. Place the tank back in
the machine.
14- Press the Cappuccino button to start the rinse cycle.
The machine dispenses the rinsing water alternately via the cof-
fee dispensing spout and via the milk carafe, with the Cappuccino
button flashing throughout this phase.
never drink the solution dispensed during this
procedure.
5- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
6- Empty the container and place it back under the milk dispensing
spout.
7- Repeat steps 5 to 6 until the milk carafe is empty, then proceed to
step 8.
8- Remove the carafe from the machine and wash thoroughly with
fresh water.
9- Fill the milk carafe with fresh drinking water up to the MAX level
and then place it back in the machine.
10- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
11-
Press the rinse button (orange). Wait until it has finished dis-
pensing.
12-
Empty the container and place it back under the milk dispensing
spout.
13-
Repeat steps 10 to 12 until the milk carafe is empty, then proceed
to step 14.
14-
Remove and wash the milk carafe as described in the section
“Weekly cleaning of the milk carafe”.
the machine must not be exposed to temperatures
lower than 0°c as the water in the circuits may freeze
(even if the tank has been emptied).
descalinG
The descaling process takes approx. 25 minutes and is split between
the descaling itself and a rinse cycle. Do not under any circumstance
interrupt or switch off the machine during either of these cycles.
Limescale builds up inside the machine during normal use. It needs
to be removed regularly as it may clog the water and coffee circuit of
your machine. The machine automatically indicates when it needs
descaling when the service indicator light (orange) is constantly
lit.
not doing this may ultimately make your machine
stop working properly, and in this case repair is nOt
covered by your guarantee.
We recommend using saeco descaling solution (sold
separately), whose formula has been designed to
respect the technical specifications of the machine, thus
ensuring its continued service in the long term and for its safe
and risk-free use. the descaling solution is to be disposed of
according to the manufacturer’s instructions and/or the
regulations in force in the country of use. the durgol descaling
solution also respects the technical specifications of the
machine.
English