Saeco SM6682/10, Manual

Page: 22 / 814

22
English
Problem Cause Solution
We advise you to perform the HygieSteam
program every day: 1) Press 'Status' on the
control panel. 2) Select 'HygieSteam'. 3)
Then confirm all steps on the display.
The milk tubes are clogged. Always store the milk container without
the milk tubes in the refrigerator. Leftover
milk could accumulate inside the milk
tubes and block the flow of milk through
the tubes. Rinse the milk tubes before
storage.
The machine seems to be
leaking. The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal. Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover. Tip: Place a
cup under the dispensing spout to collect
rinsing water and reduce the amount of
water in the drip tray.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking. Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover.
The water tank is not fully
inserted, some water is leaking
out of the water tank and air is
drawn into the machine. Make sure the water tank is in the correct
position: remove it and reinsert it into the
machine as far as possible.
The brew group is dirty/clogged. Rinse the brew group.
The machine is not placed on a
horizontal surface. Place the machine on a horizontal surface
so that the drip tray does not overflow
and the 'drip tray full' indicator works
properly.
I cannot activate the
AquaClean water filter
and the machine asks for
descaling. The filter has not been installed or
replaced in time after the screen
showed the AquaClean reminder.
This means your machine is not
completely free of limescale
anymore. Descale your machine first and then install
the AquaClean water filter.
The new water filter does
not fit. You are trying to install another
filter than the AquaClean water
filter. Only the AquaClean water filter fits into
the machine.
The rubber ring on the AquaClean
water filter is not in place. Place back the rubber ring on the
AquaClean water filter.
The machine is making a
loud noise. It is normal that your machine
makes some noise during use. If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').