EN
MACHINE SETTING
The use of a water filter (optional accessory) im-
proves the quality of the water and increases the
operational life of the machine. We suggest using
the Intenza water filter for Saeco. To install the filter
follow the directions provided with the filter.
PRIMING THE WATER CIRCUIT
6QPOUIFNBDIJOFTmSTUTUBSUVQBGUFSBMPOH
QFSJPEPGJOBDUJWJUZPSJODBTFUIFXBUFSUBOL
IBTDPNQMFUFMZSVOPVUPGXBUFSZPVOFFEUP
QSJNFUIFXBUFSDJSDVJUBTFYQMBJOFECFMPX
1
Place a container under the steam / hot water
wand and open the knob by turning it counter-
clockwise.
2
EXTRA:
press the brew button.
PREMIUM:
press the manual brew button.
EXTRA
PREMIUM
3
EXTRA:
wait for a steady stream of water to come
out from the steam / hot water wand, press
the brew button again and close the knob.
When the button is illuminated the machine
is ready to brew.
PREMIUM:
wait for a steady stream of water to
come out from the steam / hot water wand. The
dispensing phase will automatically end and the
heating will start. When the two coffee buttons
are steadily illuminated the machine is ready to
brew.
4
Remove the container used.
/PMJBCJMJUZJTIFMEGPSEBNBHFDBVTFECZ
t *ODPSSFDUVTFOPUJOBDDPSEBODFXJUIUIF
intended purposes;
t 3FQBJSTOPUDBSSJFEPVUCZBVUIPSJ[FE
service centers;
t 5BNQFSJOHXJUIUIFQPXFSDPSE
t 5BNQFSJOHXJUIBOZQBSUTPGUIF
machine;
t 5IFVTFPGOPOPSJHJOBMTQBSFQBSUTBOE
accessories;
t 'BJMVSFUPEFTDBMF
t 4UPSBHFBUUFNQFSBUVSFTCFMPX¡$ ¡'
t 6TFPGQPETPUIFSUIBOUIPTFJOEJDBUFE
*OUIFTFDBTFTUIFXBSSBOUZJTOPUWBMJE
STARTING THE MACHINE
Place the machine on flat and stable surface,
away from water and heat sources. Disconnect
the power if connected. Lift the machine using
the lifting handle (picture A). Damages to the
machine resulting from the failure to follow
these instructions will not be not covered by the
warranty.
1
Lift and remove the water tank cover, then the
water tank itself.
2
Fill the water tank up to the MAX level indicated,
using only fresh drinking water.
Hot water or any other liquid may damage the
tank. Do not turn on the machine when the tank
is empty. Make sure there is enough water in the
tank.
3
Connect the power cord and press the ON/OFF
switch to the ON position (picture B).
4
EXTRA:
power light turns on.
PREMIUM:
all buttons blink.
