English
11
fig. 2
2
5
6
8
4
User
Person authorised exclusively to operate and oversee the CAP-
PUCCINATORE. The user may switch on the CAPPUCCINATORE,
regulate the working parameters, stop the device and load the
coffee beans.
In case of any malfunction of the CAPPUCCINATORE the user
must request the intervention of the maintenance technician.
Danger
The user must not carry out procedures indicated in this manual
as the specific responsibility of the maintenance technician.
4 - DESCRIPTION OF
CONTROLS AND TOOLS
Important
The CAPPUCCINATORE is supplied with dispensing buttons
pre-programmed to standard settings (see Fig. 1).
4.1
Controls
The “CAPPUCCINO” model is set up with the following controls
(see fig. 1):
Coffee with a dash of milk key (Fig. 1, 1a)
(See “5.2 Coffee with a dash of milk dispensing”)
Programmable (See “5.5 Programming dispenser
keys”)
Cappuccino key (Fig. 1, 1b)
(See “5.3 Cappuccino dispensing”)
Programmable (See “5.5 Programming dispenser
keys”)
Hot milk key (Fig. 1, 1c)
(See “5.4 Hot milk dispensing”)
Programmable (See “5.5 Programming dispenser
keys”)
Froth adjusting pin (Fig. 1, 2)
Vertical position can be manually adjusted (See “5.6
Froth adjustment”)
Display control panel
(See Instruction and Maintenance booklet for MO-
DULAR machine)
4.2
Cappuccino dispensing unit
The cappuccino dispensing unit (fig. 2) consists of:
-
milk supply tube (fig. 2, 6)
-
retaining clip for milk supply tube (fig. 2, 5)
-
cappuccino device casing (fig. 2, 8)
-
pin for regulation of froth quality (fig. 2, 2)
-
adjustable dispensing spout (fig. 2, 4)
5 - USING THE
CAPPUCCINATORE
5.1
Warnings
• Before daily start up of the CAPPUCCINATORE carry out the
following procedures:
-
remove, clean and reinsert the pin regulating froth quality.
Failure to reinsert the pin in the hole will prevent siphoning
of milk from the container.
-
Insert free end of milk supply tube into container.
-
insert the milk supply tube in the retaining clip.
Never remove the milk supply tube from the clip during use
of the cappuccino device.
• Each time the CAPPUCCINATORE controls are activated, the
machine carries out an automatic cycle which consists of:
-
internal discharge of condensation inside spouts;
-
siphoning of milk;
-
drink dispensing;
-
steam cleaning of spout.
• The milk used in the CAPPUCCINATORE must be kept in a
refrigerator and must never be left outside the refrigerator for
longer than 30 minutes.
• If the CAPPUCCINATORE is not used for more than an hour,
carry out a cleaning cycle of the spouts before re-using.
To clean the spouts:
-
immerse the milk supply tube in a container of water;
-
press the milk key ;
-
wait until the water has been dispensed.
PLEASE NOTE:
Do not use hot water.
