800 series USER MANUAL
PROGRAMMING
12
©2020 Sabik Marine
The
set
button unlocks and locks
settings. Press this button to change
a displayed value (editable settings
only) and to lock in an updated
value. When a new value is locked,
the lantern LEDs and the LED
display will flash three times to
confirm that the new settings have
been registered and are active. If a
value is entered that is outside of the
lantern’s acceptable parameters
then
“Err” (error) is displayed, the
LEDs will flash two times, and the
lantern will revert to the previous
setting.
Turning the Lantern On or Off
The 800 series lantern can be switched into the
following two basic operating modes:
On:
The lantern is in standard operating
mode and will automatically transition
between “daytime” (LEDs off) and
“evening/night-time” (LEDs on) as ambient
light levels change.
Off:
The lantern is in an energy saving
mode with the LEDs off. The lantern will
reactivate with its last programmed settings
only once turned “on” using the IR
programmer and exposed to bright light.
An additional
“Continuous” mode is also available on
distributor demo units. Contact
activation code for this mode. To exit continuous
mode select On or Off in the Stat menu.
To turn the lantern on or off:
1. If you have not already done so,
establish a connection to the lantern.
2. The lantern LEDs will flash to confirm
the lantern is ready to receive
commands.
3. Press and hold the power button for
approximately five seconds until the
LED display changes to show
“stAt
On
” or “byE”.
