Problem
Possible Causes
What to Do
General
problems
Suds in the
tub
Improper detergent
Use only the special dishwasher detergent
to avoid suds. If this occurs, open the
dishwasher and let suds evaporate. Add 1
gallon of cold water to the tub. Close and
latch the dishwasher, then select any cycle.
Dishwasher will drain out the water at the
first step. Open the door after draining is
stop and check if the suds is disappeared.
Repeat if necessary.
Spilled rinse-aid
Always wipe up rinse-aid spills
immediately.
Stained tub
interior
Detergent with
colourant was used
Make sure that the detergent is the one
without colourant.
White film
on inside
surface
Hard water minerals
To clean the interior, use a damp sponge
with dishwasher detergent and wear
rubber gloves.
Never use any other cleaner than
dishwasher detergent for the risk of
foaming or suds.
There are
rust stains on
cutlery
The affected items
are not corrosion
resistant.
A program was not
run after dishwasher
salt was added.
Traces of salt have
gotten into the wash
cycle.
Always run the quick wash program.
without any crockery in the dishwasher
and without selecting the Turbo function
(if present), after adding dishwasher salt.
The lid of the softer
is loose
Check the lip. Ensure the fix is fine.
Problem
Possible Causes
What to Do
Noise
Knocking
noise in the
wash cabinet
A spray arm is knocking
against an item in a
basket
Interrupt the program, and rearrange
the items which are obstructing the
spray arm.
Rattling
noise in the
wash cabinet
Items of crockery are
loose in the wash
cabinet
Interrupt the program, and rearrange
the items of crockery.
Knocking
noise in the
water pipes
This may be caused by
on-site installation or
the cross-section of the
piping.
This has no influence on the dishwasher
function. if in doubt, contact a suitably
qualified plumber.
Unsatis-
factory
washing
result
The dishes
are not clean
The dishes were not
loaded correctly.
See notes in “Loading the Dishwasher
Baskets”.
The program was not
powerful enough.
Select a more intensive program.
See “Wash Cycle Table”.
Not enough detergent
was dispensed.
Use more detergent, or change your
detergent.
Items are blocking the
path of spray arms.
Rearrange the items so that the spray
can rotate freely.
The filter combination in
the base of wash cabinet
is not clean or is not
correctly fitted. This may
cause the spray arm jets
to get blocked.
Clean and/or fit the filter combination
correctly. Clean the spray arm jets.
See “Cleaning the Spray Arms”.
112
111
GB
GB
