Page 2 of 5 - Info sheet 007, version 080514
SABA Dinxperlo BV
Industriestraat 3, NL-7091 DC Dinxperlo, Postbus 3, NL-7090 AA Dinxperlo, Visiting address: Weverstraat 6, NL-7091 CM Dinxperlo,
Tel +31 (0)315 658999, Fax +31 (0)315 658989, E-mail [email protected], Internet, www.saba.nl, Trade register Arnhem 09065419
Our recommendations and conditions for use are based on the present status of know-how and technology. Customers and users should assess our
products themselves for the desired application and demands. We are not responsible if our products are applied without considering our advice and/or
conditions for use. Furthermore the General Conditions of the Dutch Association of Rubber and Synthetic Manufacturers, dated 01.01.1992, are applicable
to our advice and conditions for use and the delivery of our products.
1. Introduction
The Sealer Lance LD 40, developed by SABA, has been designed for
using SABA Sealer Field in applications like sealing expansion joints at
airports.
The Sealer Lance LD 40 should be used in combination with a pressure
tank and a compressor and a power unit on a cart.
2.
Using the Sealer Lance LD 40: work specifications
Read these specifications carefully before starting to assemble the equipment, so that safe use is
guaranteed. Customers and users should assess and check the equipment themselves for the desired
application and demands. We are not responsible if the equipment is used without consideration of our
advice and/or conditions for use.
1. Check if the set supplied is complete and that all specified parts comply.
2. The parts of the LD 40 which come into contact with the SABA Sealer Field should be coated in
Vaseline to ease cleaning.
3. For safe use of the LD 40 it is advisable to not exceed a
maximum
working pressure of 6 Bar.
(The factory safety instructions must be taken into consideration.)
4.
WARNING!
All parts should be assembled and fixed before the equipment is pressurized; in view of
the outflow speed we advise that the starting pressure is not too high.
5. Turn the hose socket
(F)
under the pressure tank and then connect the PVC hose
(B)
to the hose
socket
(F)
and fasten it with the hose clamp
(E)
.
6. The PVC hose
(B)
between the LD 40 Sealer Lance and the pressure tank may have a
maximum
length of 3.0 metres.
7. Then fix the PVC hose
(B)
to the spray unit
(A)
and fasten it with a hose clamp
(E)
as well.
8. Fix the grey Cox nozzle
(D)
onto the spray unit
(A)
of the LD 40 (see photo).
9. Cut the spray opening of the grey Cox nozzle
(D)
to fit the width of the joint.
F F B B E
E A
B B
E F E C D
