DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
The speed controller (ESC) is installed in the front of the helicopter.
Figure 1:
Show the ESC support. You can use hole or slot in according with your ESC.
Figure 2:
Show the installation of the ESC from HOBBY WING 130A V4.
Figure 3:
You can see the wiring for connecting the ESC to the central unit.
Route the ESC throttle wire as shown, It is reccomanded to ues cable ties to keep the wire in place.
This is very important near the tail belt.
Page 19
Chapter 10, Installation Of The ESC, FBL and RX