Note:
Larger ID
Note:
Smaller ID
Approx 76.6mm
BAG 6.1, BAG 6.2
Center Hub Assembly
Center Hub
(H0130BM-S)
Oring
(HA024)
Damper Derlin
(H0426-C)
Spindle
(H0097-S)
Radius Arm Assembly ... x2
Uniball Arm Assembly ... x2
Flanged Bearing
2.5x 6x2.5mm
(HC400-S)
Spacer Arm
2.5x 4x6.3mm
[H0253]
Uniball
Radius Arm
[H0205]
Flanged Bearing
3x 7x3mm
(HC402-S)
Radius Arm
(H0132BM-S)
Spacer Arm
3x 5x2.7mm
[H0134]
Main Blade Grip Assembly ...x2
Blade Grip
(H0679BM-S)
Blade Grip Arm
(H0131BM-S)
Bearing
10x 19x5mm
(HC422-S)
Socket Head Cap
Screw M3x10mm
(HC056-S)
Uniball M3
(H0065-S)
Note:
The HPS head should be assembled with one, 1mm shim (HC230) and one,
0.2mm shim (HC232) on each side. The blade grips must move freely, but
they should not move just under their own weight. If the blade grips are too
tight, you can remove the 0.2mm shim (HC232) from each side. After
approximately 10/20 flights, please check preload, you can add one or two
0.2mm shim (HC232) if preload has changed.
Socket Head Cap
Screw M2.5x18mm
(HC032-S)
Uniball Arm
Assembly
Radius Arm
Assembly
Socket Head Cap
Screw M3x16mm
(HC068-S)
Washer
3x 4x0.5mm
(HC176-S)
Linkage Rod
Assembly
Main Blade Grip
Assembly
Thrust Bearing
10x 18x5.5mm
(HC438-S)
Washer
10x 16x1mm
(HC230-S)
Bearing
10x 19x5mm
(HC422-S)
Washer
6x 14 x1.5mm
(HC194-S)
Socket Head Cap
Screw M6x10mm
(HC124-S)
Washer
10x 16x1mm
(HC230-S)
[HC232-S]
Linkage Rod A Assembly ...x2
Plastic Ball Link
(H0402-S)
Plastic Ball Link
(H0402-S)
Linkage Rod
M3x50mm
(H0417-S)
(Initial length for the rods from the swashplate
to the Blade Grip.)
eg: Microlube GL261
eg: Microlube GL261
Chapter 6,Head
Page 13