26
Lead-Me-To-Car
Lead-me-to-car feature activate/deactivate the
interior lights and exterior front parking lights
and rear brake lights by the press of a button
on your remote control.
Brake light
If a brake light bulb burns out, the same side
taillight will adjust its voltage to burn brighter
when braking and provide for your safety until a
new bulb is installed.
Emergency trunk release
handle
After exposed to daylight, this handle will glow-
in-the-dark.
Night panel
In this mode, the amount of information
displayed on the dashboard is reduced to avoid
driver distraction. When NIGHT PANEL has
been selected, only the speedometer will be
illuminated. All other instrument lighting will be
switched off and the needles in the main instru-
ment panel drop to zero. All indicator, warning
lights and messages will appear if required.
(See your Owner's Manual, section Instru-
ments and controls).
Passenger side door mirror angles
down when reversing
3
On certain models, the passenger side mirror
glass can be angled down to help you when
reversing. After selecting Reverse gear, press
the button located under the touch pad for
mirror adjustment. The passenger side door
mirror will angle down to provide a better rear
view. Pressing the button again will return the
mirror to its normal position, or will automatically
return once you drive forward about 65 feet.
Saab Parking
Assistance
3
Four sensors in the rear bumper help you in
parking. Signals bounce back from objects
behind the car. When reverse gear is selected,
the system activates automatically and when an
object is detected within the monitored area,
pulses of sound are heard. The frequency of
these pulses increase as the car comes closer
to the object, When approximately 1 ft (30 cm)
from the object, a continuous tone will be heard.
NOTE: the system cannot always detect small
or narrow objects (like a mailbox post) since the
surface area presented to the sensors is too
small. Always take care when reversing.
(See your Owner’s Manual, section Starting
and driving).
Courtesy Headlamp
Courtesy headlamp feature allows headlights
and reversing lights to remain on for 30 seconds
after you exit the vehicle. To activate:
1 Remove the ignition key.
2 Open the driver’s door.
3 Pull the turn signal indicator switch towards
you and release (as if you were flashing your
lights).
4 Exit the car and close the driver’s door.
(Your dealer can adjust the time the lights
stay on.)
