12 801 443 17
Saab 9-3 4D M03-
61 Locate the loose fibre optic cable and the con-
nector with the fibre optic cables connected by
the left-hand A-pillar (taped to the cable duct).
62 Lift up the connector lock tab.
63 Remove the fibre optic cable from the position in
the connector where the arrow points outwards,
to the fibre optic cable.
64 Remove the fixing tape from the loose fibre optic
cable.
65 Remove the protective cover from the connection.
66 Fit the protective cover onto the removed fibre
optic cable connection and carefully move the
fibre optic cable aside in order to prevent dam-
age, and position it behind the wiring harness.
67 Fit the connection on the new fibre optic cable in
the position in the connector where the arrow
points outwards, to the fibre optic cable and fit
the lock tab.
WARNING
The visible red light is a class 1 laser. Do not look
directly into the optical fibre or the control module
connector at close range. A distance of less than
20 mm between your eyes and the light source
may cause eye injury.
Important
Handle the fibre optic cables with care or the
signal may be distorted.
·
It is very important that the two leads in the
connector are not confused with one another.
·
Do not bend the cable in a radius smaller than
25 mm.
·
Keep the cable ends free from dirt and grime.
·
The cable should not lie against any sharp
edges as this may cause increased signal
reduction.
F930A362
62
61
61
67
