Follow the instructions of the illustration below to explain
1. Select TCP Server server mode, here is the working mode for the computer, because the
above is a converter The setting is the client mode, so here is the setting.
2. The local IP setting is the IP of the computer
3. The 23 here is the remote address mentioned above.
4. After clicking , it becomes , The most important thing is to look
at the content in the red circle below. It needs to be the same as that in the circle, that is, it will be
displayed like this when the converter is connected to the computer. Only in this way can you set 5, 6, 7,
and 8 to be the same as those marked in the above figure, and then you can operate.
If it does not appear the same as or similar to the ones in the circle (the format is the same after modifying
the IP and port). Then check whether the previous settings are consistent with the description in this article.
If the information in the red circle appears, then the following communication experiment can be carried
out:
5. Through Wiegand transmission, connect the Wiegand device to the converter, swipe the card or enter
the password, etc., and you can receive the content through the network port as shown above
6. If the 4P TTL to serial port is also connected at this time, then the data can also be seen on the serial
port at the same time, this is the content to be discussed below
18
/
23
1
2
3
4
5
6
8
7
Summary of Contents for WIEGAND-Ethernet
Page 1: ...1 23 Ethernet WIEGAND Bidirectional converter Manual...
Page 13: ...13 23...
Page 21: ...21 23...
Page 22: ...22 23...
