Installation
Step 1:
Please stick the sticker on the desired mounting position (Please refer to Fig.1) and drill holes
according to the sticker's indicated positions. Remove the sticker after drilling a hole for wiring.
Step 2:
Remove both sides of the lock's covers A and pull out the B.(Please refer to Fig.2- Fig.4)
Use screws to screw the body lock tight on the appropriate position. Place all covers back in order.
2
Control Panel
Voltage and Delay Time Adjusting
N.C
COM
N.O
P.S
V-
V+
LED
Door open
switch
Wiring hole
Delay time
switch
Voltage
adjusting Jump
Indicator light
Door
Frame
Alignment
sticker
Drilling
positions
Wiring hole
Fig1
Drilling positions
Screws
Screws
Wiring
hole
Fig2
Fig3
Fig4
A
B
1. Door open buttons have both built-in and external inputs. Please use both V- and P.S. Points
for external door open button. Both built-in and external door open buttons are able to be
used at the same time. (Please refer to the diagram above) .
2. Door Lock status (N.O/N.C) as Relay output. Maximum load of 1A@24VAC.
3. Indicator light is green when the door is locked, or else the door did not close tight.
Attention
Adjusting Volatge
P.S
V -
External door open
push button
Delay time Setting
