LoadSentry
Instruction Manual
MANU
Digital load measuring system
S2Tech srl
Via Imperia, 28 Milano
ITALY
Tel: +39 02 8910142 - Fax: + 39 02 89124848
e-mail:
www.s2tech.it
Version : UK 3r3 dated 05/05/17
Page: 4/6
699PLUS CONTROLLER CONNECTIONS
Screw Terminal
Meaning
1
GND (DC POWER SUPPLY)
2
+ 24 V (DC POWER SUPPLY)
3
EARTH connection
4
CONTACT I/O 2 (Display
Zeroing
)
5
CONTACT I/O 1 (Chain compensation)
6
I/O CONTACT's common reference
7
Relay 3
-
Normally Open contact
8
Relay 3
-
Normally Closed contact
9
Relay 3
Common contact
10
Relay 2
-
Normally Open contact
11
Relay 2
-
Normally Closed contact
12
Relay 2
Common contact
13
Relay 1
-
Normally Open contact
14
Relay 1
-
Normally Closed contact
15
Relay 1
Common contact
16
+ power supply to transducer
17
- power supply to transducer
18
+ signal form transducer
19
- signal from transducer
23
AGND (Analog output)
24
Analog Output
Ground to earth the 699 electronics
and
respect all the relevant safety and electrical
regulations
.
Once performed all the needed electrical connections feed power supply and wait 15
minutes, before calibrating.
Measurement changes are displayed in tens of the used
engineering units.
POWER SUPPLY = 24 Vdc
699PLUS CONTROLLER
QTY 1 699Plus weight controller
QTY 2 Fixing screws, type M4 x 12 UNI 7687
QTY 2 Nuts, type M4
PUSHBUTTONS AND THEIR ACTION for 699Plus programming
Use
or
to view available parameters.
Use
E
to view and modify existing numeric parameter or to confirm changes to parameter.
699Plus indicates that new parameter has been accepted by showing, briefly,
MEMO
and
Use
C
to:
abort changes to numeric parameter, maintaining the existing value
end calibration SAVE changed parameters - and start load measurement
To modify numeric parameters, use
to increase or
to decrease value of one unit.
+
E
increase value of 10 and then 100 units while
+
C
decreases of 10 and then 100
units.