ADDENDUM 699Plus
A1- Analog Output
Digital load / weight measuring system
S2Tech srl
Via Imperia, 28 Milano – ITALY
Tel: +39 02 8910142 Fax: + 39 02 89124848
www.s2tech.it
Version : UK 1r0 dated 01/06/18
Page: 1/1
Notice:
The information in this manual is subject to change without notice.S2Tech shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This manual contains information protected by
copyright. No part of this manual may be photocopied, or reproduced in any form, or translated without prior written consent from S2Tech.
Z:\Manuali\699Plus 2k17\Addendum_699A1 AnalogOutput UK .docx
A) 699 Plus electronics Analog Output setting (Optional)
Making reference to the 699 customization procedures, parameter setting for analog output signal must be done considering the
following flowchart:
Note
: the analog output circuit provides an analog output signal for all operative modes. The firmware version is to be at least
1.17 or higher. To obtain a reversed 10V to 0V output, calibrate DACL with high engineering units (measuring range) while on
DACH enter lower ones. Analog output signal connection is as per attached connection scheme.
DMODE = 1
DMODE = 0
Note
: 0 to 10V output signal is available for 699 Plus A1 electronics (code 00.03.010.0010).
B) Analog output connection scheme for code 00.03.010.0010:
Analog Signal A1 = from 0 to 10V
AGND = analog signal GND
NOTE:
In order to obtain the best accuracy from the instrument’s analog output signal,
use 3 wires
to connect the lift’s
Inverter to 699Plus analog output.
WARNING: POWER SUPPLY MINUS, provided to 699Plus instrument is NOT the AGND analog output
ground. Power 699Plus with a floating power supply.
Document history
0
010618
First issue
699Bv1.00
699V1r0
S.Piardi
D.Disanto
Rev.
Date
Description
Firmware
Hardware
Writer
Check
