S-WORKS Specialized Shiv TT, Instruction Manual

Page: 18 / 24

Page 16 of 20
3.2 INSTALLING THE RISERS AND CROSSBAR
35
45 55 65
45mm
Upper
Riser
Cap
35mm Riser
Lower
Riser
Cap
55mm
45mm Riser
65mm
55mm Riser
75mm
65mm Riser
Crossbar
Handlebar
Riser height includes crossbar thickness, measured from top of handlebar to top of crossbar.
C
C
C
C
B
B
B
B
The risers (3-C) cover the 45-75mm range in 10mm increments. The riser height measurements (45 / 55 / 65 / 75mm) include the
thickness of the riser caps (x2) and the crossbar. The riser extensions alone measure 10mm less than the final measurement (fig.2 inset).
Lateral extension width is set at 110mm when using risers and crossbar (see fig.4).
1. Riser bolts thread directly into the risers from above (15mm, through the riser crossbar (3-E)) and below (30mm, through the handlebar (3-F)).
2. Grease then place 4 riser bolts (B) (M6 x 15mm) through the inner bolt holes of the crossbar from above, then through the riser caps (3-D) and into
the top of the riser (3-C). Riser caps are specific to top, bottom, left and right.
3. Torque the bolts to 80 in-lbf (9.0 N*m).
To ease installation (especially with shorter risers), install the extensions and desired spacers (see step 3.3, page 17) onto the crossbar
before installing the risers to the handlebar.
4.
Grease then place 4 riser bolts (C) (M6 x 30mm) through the holes in the handlebar from below, then through the riser caps (3-D) and into the
underside of the risers (3-C).
5. Torque the bolts to 80 in-lbf (9.0 N*m).
3-D
3-F
Bolts (B) through
crossbar, into risers
Riser
Height
Bolt
Length
45, 55, 65, 75 15
Bolts (C) through
base bar, into risers
Riser
Height
Bolt
Length
45, 55, 65, 75 30
2
3-E
3-C