For Effective Cooling
Close the windows and pull down blinds. Sunshine is reduced and cooling efficiency increases.
Paste heat shield film on the window. Heat entering the room is reduced.
Block the outdoor unit from direct sunlight. This saves energy.
Maintenance While in Use
The unit should be cleaned regularly
Turn off the power supply before cleaning
Clean the indoor unit using a soft cloth. If the unit is very dirty use a solution of detergent in lukewarm
Clean the air filter regularly (Refer to the section of leaning the air Filter )
If the outdoor unit is installed on the roof, Clean the surroundings around the outdoor unit regularly to
prevent dirt or rubbish from blocking the heat exchanger.
When the Air Conditioner is not going to be used for a long time
Perform FAN operation for 3-4 hours to dry the inside of the air conditioner.
Remove the batteries from the remote control
Disconnect the power plug or switch off at the mains power.
Preparation and maintenance when the air conditioner is to be used again
Clean the air filter and install ir in the indoor unit.
Connect the power plug or switch on at the mains power
Check that the air inlet and outlet of the indoor/outdoor units are not blocked.
CAUTION
Do not operate the air conditioner without the air filter installed.
Do not use gasoline benzene, polish powder, detergent or hot water more than 40
Operation and Maintenance
Efficient Operation
In order to increase the efficiency of the operation and considering your health we recommend you use
the unit as follows.
If the air conditioner cannot be operated ensure:
1. The power plug is connected. The switch is turned on and the fuse is not blown
2. The leakage breaker is not turned off
3. The power source is current
Before Contacting the Serviceman
4. The air conditioner keeps stoping during operation. Test the power by pressing the ON/OFF button again
5. The ON timer is not set.
The air conditioner does not cool or heat sufficiently. Check
1. The temperature setting is correct. The set temperature should be lower than the room temperature in
COOL mode. While in heat mode the set temperature should be higher than room temperature.
2. If a door is open or there are too many people in a room or other electronic appliances are generating
heat from operating.
3. Outlet and inlets of the outdoor unit are not blocked
4. Air filter is not dirty.
Display on remote control does not appear or the remote control signal cannot be received. Check
1. The batteries are exhausted
2. The polarity (+) (-) of the batteries is confused.
CAUTION
During a thunderstorm stop operation and pull out the power plug or turn off the mains switch as damage
maybe caused to the electrical parts.
In a weak radio wave area when the air conditioner is operated it may cause noise in SW radio reception.
The remote control signal may not be received in a room where an electronic type fluorescent lamp is used.
If the above items are checked and the air condition does not recover stop using and contact the service
dealer or the manufacturer advising the producttype and the failure details.
water then clean it again using a soft damp cloth.
10|
Page
11 |
Page
Summary of Contents for TKF-26GW/BP
Page 3: ......
