13
Sigma S1 Installation Manual
Si
gm
a
S1
Insta
llat
ion
Man
ua
l
9.3.
Frameless Modules
–
Portrait
1.
Insert a laminate end clamp into the purlins.
2.
Place the frameless module on the purlin and
insert it into the laminate end clamp leaving at
least a 1mm gap.
3.
Insert a laminate mid clamp into the previously
installed module. Place the next module on the
purlin and insert it on the installed laminate
mid clamp. When inserting the modules into
the laminate mid clamp, remember to leave at
least a 1 mm gap.
4.
With the module’s clamping points correctly
aligned with the laminate clamps, tighten the
clamp to the module.
5.
Repeat the above steps for the rest of the row
of modules. At the end of the row, install a
laminate end clamp on the outside of the last
module to complete the row.
9.4.
Frameless Modules
–
Landscape
1.
Insert a laminate end clamp into the bottom
purlin. Place the frameless module on the
purlin and insert it into the laminate end clamp
leaving a 1mm gap.
2.
Insert a laminate mid clamp into the next
purlin and insert the installed module into it.
Install the next module by inserting it to the
installed laminate mid clamp. When inserting
the modules into the laminate mid clamp,
remember to leave at least a 1mm gap.
3.
With the module’s clamping points correctly
aligned with the laminate clamps, tighten the
clamp to the modules
4.
Repeat the above steps until the topmost
purlin is reached. At the end of the column,
install a laminate end clamp on the outside of
the last module to complete a column.
5.
Repeat steps 1-4 to install another column of
modules.
Image 9.3
–
1 Laminate End Clamps in Portrait
Image 9.3
–
2 Laminate Mid Clamps in Portrait
Image 9.3
–
3 Portrait Installation
Image 9.4
–
1 Laminate Clamps in Landscape
Image 9.4
–
2 Installing next column of modules
