7
B A S I C O P E R AT I O N
When connected to an approved, 12VAC, Class 2 power supply - The S.R.Smith
kēloXL
LED color
changing light uses simple ‘off / on’ power switching to control the basic, pre-defined color modes
with memory function.
MEMORY
The memory function remembers the last color
setting. For example, if the light was last used in
the blue mode, the next time the light is turned on
it will be blue mode.
COLOR MODE SELECTION
The LED will turn on to the color in memory. To
move to the next color mode, quickly (within one
second or faster) toggle the power to the lights
’OFF / ON’.
Advance through the modes until the desired mode
is selected. The modes will cycle 1,2,3,4,5,6,7,8,
then cycle back to 1. See table below for details.
COLOR SYNC RESET
To synchronize all lights on the system including older *Fiberstars LED Series Pool lights, you
must use the following sequence:
1. Turn lights ‘ON’ to confirm the color modes are out of sync.
2. Turn lights ’OFF’ for 5 seconds or more.
3. Toggles lights ’ON’ / OFF’ three times within three seconds - must end in ’OFF’ condition
4. Leave lights in ’OFF’ condition for 5 seconds.
5. Turn lights ‘ON’ and confirm that all lights are in mode #1, Soft Color Change
FOR LED COLOR CHANGING MODELS (RGB)
WHITE ONLY LAMPS ARE SIMPLY ON OR OFF
COLOR MODE SELECTION GUIDE
Mode 1
Soft Color Change
Mode 2
White
Mode 3
Blue
Mode 4
Green
Mode 5
Red
Mode 6
Amber
Mode 7
Magenta
Mode 8
Flash Color Change
*Older Fiberstars LED lights can synchronize with the newest generation lights
ONLY if they have their DIP switches in their default, ’All Down’ position. In a mixed
environment, the Color Sync Reset will need to be performed each time the lights
are used, and color synchronization is desired.