INSTALLATION MANUAL
EDGE DIVING SYSTEM
10
srsmith.com
Fig. 2
Fig. 3
Edge aquaBoard™
Edge aquaBoard™
D) Attach the waterfall unit to the Diving Board by inserting the 4 provided screws thru the holes in the waterfall assembly; hand
tighten only (DO NOT USE SCREW GUN), over tightening the screws will cause them to strip inside the board or break the
waterfall housing, and voids the warranty.
3. BASE PLUMBING DETAILS:
Remove the black cap on the top of the base. (Fig. 4) Pass the hose through the base. (Fig. 5) Coil up any excess hose under the
base. (Fig. 6)
Fig. 4
Fig. 5
Edge aquaBoard™
Edge aquaBoard™
Fig. 6
Edge aquaBoard™
STEP ONE: INSTALL BOARD FALL WATER FEATURE ON EDGE aquaBoard™:
If purchased, attach the optional waterfall assembly to the underside of the Edge aquaBoard™ as follows:
IMPORTANT: To keep the BOARD FALL from clogging when installing on a Sand Filter System, an in-line cartridge filter is recommended
on the BOARD FALL water supply line.
A) The BOARD FALL comes from the factory with an 8’ length of 1/2” flex PVC pipe attached. The 8’ length goes thru the board
and attaches with PVC glue to one side of the 1/2” union. The 4” length of flex PVC pipe attaches with PVC glue to the stub-up
and then to the other side of the 1/2” union.
B) Once the water tubing is threaded all the way through the diving board, from the base side, gently pull the end of the tubing until
the waterfall assembly is pulled gently into the BOARD FALL receiver on the top of the diving board.
C) Mark the hole locations for attaching the BOARD FALL unit to the board.
For an Edge aquaBoard™: Locate the BOARD FALL unit all the way to the back of the BOARD FALL receiver. (Fig. 2) Make
sure the hose is threaded through the channel as shown. (Fig. 3) Using a 1/8” drill bit, drill the 4 holes 1/2” deep. Use tape to
mark the drill bit depth. IMPORTANT: Do not drill the holes deeper than 1/2” as there is a risk of drilling all the way through
the board.
