700-3000 6.21.2016
11
This lift seat assembly is designed to be used exclusively with S.R. Smith aquatic access lifts.
UNPACKING & ASSEMBLY INSTRUCTIONS
REFER TO THE DIAGRAM (page 6) FOR PARTS IDENTIFICATION.
READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE BEGINNING INSTALLATION
Prior to opening the shipping pallet, carefully inspect the external condition of the shipping
materials for any visible damage. It is important that any damage be noted on the Bill of Lading
prior to signing for the delivery. Contact either S.R. Smith or your dealer immediately to notify us
of any damage or missing parts.
Ensure mounting anchor has been installed in the correct location in the pool deck for proper lift
operation. It is recommended that the anchor be installed by a person familiar with installing pool
deck equipment.
The aXs is shipped on a covered pallet and is mostly assembled; no tools are required for installation and
setup. Position pallet close to deck anchor for easier assembly and set up.
Unpacking & Assembly Procedure for the aXs:
1. Carefully remove plastic covering from pallet.
2. Carefully remove any wood bracing from pallet.
3. Remove seat assembly and set aside for attachment.
4. Remove lift from pallet and place into deck anchor.
5. Remove and unwrap hand control from accessory carton. Insert plug into large connector on the
Control Box and hang hand control on handle. Make sure plug is secure.
6. Ensure pre-installed plugs are secure in sockets marked 1 and 2
7. Attach battery to Control Box. To remove battery pull slightly away from mounting plate and lift
battery pack off of the Control Box.
8. Cover Control Box and battery with Console/Battery Cover to protect from moisture.
9. Check up and down controls for proper operation - both touch pad and hand controls.
10. Check side to side controls for proper operation – both touch pad and hand controls (4 Button
Control only).
11. Check Emergency Stop button for operation/activation of internal sounder.
12. For Controls with the optional Activation Key – Key must be inserted into slot for operation. When
Key is removed lift with not operate. (Note – Emergency Stop button and alert will operate without
Key inserted into slot)
13. Attach battery to Control Box.
14. Rotate lift so that the seat arm is positioned over the pool deck.
