100
CompTrol Interface V4.0.x | Issue 21-05-2021 | 1000932
Installing the CompTrol Interface expansion module
8.
Check the DIP switch settings and connection assignment.
9.
Fill out the start-up report (see “Table 76: Spare parts” on page 109).
The start-up report is available to download from the S-Klima website:
www.s-klima.de/downloads
Result
– The CompTrol Interface has been installed and can be put into operation.
Note
●
For installing, connecting, and wiring CompTrol Interfaces in combination with a CompTrol
Master for program 10, see the CompTrol Master Technical Manual. Program 10 is available
with CompTrol Interface V4.0.3 or higher.
IMPORTANT
Damage to the CompTrol Interface by reversing the polarity of terminals X5-(+) and X5-(-).
●
Ensure the correct polarity for terminals
X5-(+)
and
X5-(-)
.
17.5 Starting up the CompTrol Interface expansion module
17.5.1 Initialization
The initialization phase commences when the CompTrol Interface is connected to the X/Y remote
control bus. During this initialization phase, only the 7-segment display is active. None of the
digital outputs or inputs are active. The CompTrol Interface ignores changes to analog signals
during the initialization phase.
17.5.2
Initialization sequence
1. Both dots on the 7-segment display light up for 3 seconds.
2.
The individual segments of the 7-segment display flash in a synchronous cycle as a display
self-test.
3.
The software version number, e.g. 4.0, is shown for approximately 1 second.
4.
A countdown ticks down.
–
If the CompTrol Interface is configured as a slave, the countdown runs from 3 to 0: dura
-
tion approx. 1 second.
–
If the CompTrol Interface is configured as a master, the countdown runs from 15 to 0:
duration up to 3 minutes.
5.
After the countdown, the number of the selected program is shown for approx. 1 second, e.g.
“08” for program 8.
6.
Next, the parameters set via DIP switches
S2-7
and
S2-8
are shown.
Note
●
For starting up CompTrol Interfaces in combination with a CompTrol Master for program 10,
see the CompTrol Master Technical Manual.
Summary of Contents for CompTrol
Page 125: ......
